[sdiy] How do you make those module panels?

[patchell]

    I don't know if this has been covered before, and maybe somebody has
already looked into this.

    I have always like dry transfers, but, when you have to apply the
stuff one letter at a time, it does get quite tedious, plus, you do have
access to a lot of the graphics you might want.

    I am sure some company out there must to custom dry transfers.  I
was thinking in terms of covering the sheet with all of the common words
one might use on a DIY synth, plus graphics for pots, etc...

    I have only looked casually into this.  So far, I have not really
found anybody who does this.  And then again, maybe this is not even a
worthwhile pursuit.


Steve Ridley wrote:

> > could use some pointers on making nice looking module panels.
>
> This has been covered in detail on SDIY before, so a look through
> the archives is well worth while.
>
> Also, take a look at:
>
> www.megauk.com
>
> A mine of information about different panel labelling systems.
> They'll sell you everything from a professional screen printing
> equipment to the "Quick-Laser" system I use for my panels
> (available from Rapid Electronics too) and a variety of other
> systems in between.
>
> Steve Ridley

--
 -Jim
------------------------------------------------
* Visit:http://www.silcom.com/~patchell/
*-----------------------------------------------
*I'm sure glad Merry Christmas comes just once a year
* -Yogi Yorgensen
------------------------------------------------