[sdiy] nord modular control knob

[Theo]

Err, just a guess but this sounds like a job for Clavia to me.
I don't have a North modular to check,
but from your description the "pot" is probably a "encoder".
Finding a replacement should not be too hard.
However what really worries me is the "bend" circuitboard,
according to what you write it seem bend rather worse,
while it shouldn't bend at all.

Theo


From: Rude 66 <r.lekx at chello.nl>


> guys (and girls!)
>
> can anyone tell me anything about the big round controller knob on the
nord
> modular? (the one you go through the patches with).. i have one here where
> the knob is all loose, and doesn't make contact anymore. on opening it up,
> it looks like the knob was pushed down too hard and the circuit board
> underneath bent. when i push it back, it still doesn't make good contact
> with the small metal bits on thew actual pot. it's supposed to 'click' but
> it doesn't.
> would this be fixable? or does it need to be replaced? where would i find
> these?
>
> thanks and have an excellent solder-drenched 2003 you all!
>
> r./
>
>