[sdiy] 76477 "N" vs "NF"

[John Blacet]

Thanks to everyone for all the suggestions!

Unfortunately the .070 pitch looks a lot more like SMT than DIP. I would
hate to solder anything to those pins. If I had to, I would bend up
every other pin to give some room for soldering.

The difference in width from the "N" to "NF" is only 0.2", leaving only
0.1" on each side to run traces if you were going to design an adaptor
board. It would have to be doublesided and it would be a challenge.

I guess these go back to the vendor.

Anybody want 100 brand new shiny 76477NF?

Regards,
--/////--
John Blacet
Blacet Research
http://www.blacet.com