[sdiy] Wiring pcb pots

[Elby Designs]

Hi,
I am wiring up a front panel that uses a range of sealed pcb-mount pots and am wondering how you wire to these devices. These pots have legs that are about 3mm long and are on a 0.1" pitch so they are very flimsy and very close together. Attaching a single wire to each leg is not a real problem but when daisy-chaining legs from one pot to the next is a slightly different story.
Does anyone have any suggestions as to best wire this sort of pot? A picture of the pots can be found at www.ozemail.com.au/~boobies/datasheets/resistors.pdf and are the green 9mm pots.

Best Regards
Laurie Biddulph
http://www.ozemail.com.au/~boobies
Mobile: 0404 846 943

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20030421/03f4b678/attachment.htm>