[sdiy] AlumaJet part 2

[harrybissell]

Still working with AlumaJet... score is AJ 3 - Harry 0

The first panels were 'ok' but I fvcked up the spray coating...so I
tried
a polishing compound (fairly sucessful)...

but then I tried to apply a final caot of Lacquer... BIG mistake
(if you are into paint you know what 'fisheyes' are...)

So I did an additional panel... which jammed in the paper feed
Tried to save some of that panel, but it was too short, because of the
jam.

So panel 3, I adjusted the paper feed 'looser'... now it can slip a tiny

bit
so the length is no longer 'spot on' (as our UK brothers say...)

I'm going to try and salvage #3 later tonight. Its just a tiny bit
short...

Also, I tried Frontpanel Designer...  that is looking REAL good for
panels
right about now  :^)

H^) harry