200e

Please do not make the deadband larger.  I think it's a bit big as it  
is (sincerely)


On Jul 18, 2008, at 10:16 AM, ezra buchla wrote:

> ok, i'll rephrase: is the modulation you notice at the detent positive
> or negative? if it's positive, can you make it get smaller buy turning
> it to the left? if it's negative, can you make it smaller by turning
> to the right?
>
> there is some position that will be read as a no-op; the dead band is
> programmed in firmware. we could reprogram the dead band to be bigger,
> but this could potentially throw off many users including myself.
>
> On Fri, Jul 18, 2008 at 3:45 AM, kai200e <kai200e@yahoo.com> wrote:
> > Hi Ezra,
> >
> >>
> >> are you working with cv or fm input?
> >
> > for sure with cv input.
> >
> >>
> >> assuming you're working with cv: is there any position you can  
> place
> >> the knob that does successfully zero the modulation? like slightly
> >> left of the detent?
> >
> > no there is no point without. As soon as you input the connection  
> you
> > can hear the Modulation. (while the knob is in center position)
> >
> >
>
>