The Yamaha AN1x Synthesizer mailing list

the only problem is a -10dbu signal on a +4 so the signal will be a lot quieter than if using a balanced signal

also if the an1x output uses common ground for its output ground you can get noise earth loop from the connected balancing equipment unless its a floatin system via a balancing trafo which it does not mater 
  ----- Original Message ----- 
  From: william.bromell@... 
  To: AN1x-list@yahoogroups.com 
  Sent: Thursday, September 05, 2013 8:37 AM
  Subject: [AN1x] Using Balanced Cables with AN1x


    
  Does the AN1x accept TRS cables without any problem? I'm trying to connect the unbalanced outputs to a balanced input (XLR). I could get a TS to XLR cable, but it would be easier to just use TRS to XLR. 

  
  No virus found in this message.
  Checked by AVG - www.avg.com
  Version: 2014.0.4158 / Virus Database: 3614/6755 - Release Date: 10/16/13