Yahoo Groups archive

AVR-Chat

Index last updated: 2026-04-28 22:41 UTC

Message

ATtiny25 *RESET question

2007-10-21 by Thomas Keller

So, I have this cute little device I have developed for model
railroaders.  Based on an
ATtiny25.  Question:  for this device to start functioning when the
power is applied, do I need to connect the *RESET pin (pin 1) to something? 
Perhaps a resistive network to ground, with a small cap across the lower 
(grounded) resistor?

tom

Attachments

No local attachments were found for this message.