Hello
everyone, I have been having some strange problems with programming a 8515 chip
using Bascom and a STK500 and hope that someone may have a clue as to why.
I
compile a program in Bascom without any errors and then opt to program the 8515
chip in the STK500.
A Dos window appears and the erasing and checking
proceeds fine.
Next
the programming starts and then stops with the FAILED message and the Dos
window closes and reverts back to Bascom.
The STK500 shows an error condition and the
program does not run.
If I
try and program again with the same program, the DOS window opens and closes
with a FAILED message straight away and the program now runs as it
should.
If I
use CAVR or AVR STUDIO directly with the the Bascom generated hex file, the chip
programs ok and all is fine.
Any
ideas appreciated as I have a finite amount of hair left to tear
out!
Doug
Locke