AVR-Chat

Thank you very much to all of you, it's finally working.
I took your suggestion and I removed the diode/resistator I had and instead put one of each on 87a of both mirrors.
 
http://img209.imageshack.us/img209/4048/finalmirrorcircuit.png
 
:)
 
 

________________________________
 From: R E Purcella <repurcella@clearwire.net>
To: AVR-Chat@yahoogroups.com 
Sent: Friday, May 18, 2012 12:44 AM
Subject: Re: [AVR-Chat] Circuit 2.0
  
Previously the circuit was to have half brightness with running lamps. 
To do that you should have 2 separate current resistors, one for each 
LED into 87a contact. What I see happening is the current to the right 
side is spiking up when the left side circuit breaks. The resistor 
delivers the same amount of current but now it goes to just one side, 
and it gets brighter.

rep

On 5/17/2012 7:11 PM, Kenny M. wrote:
>
> Hey guys me again :) I gave up on that other circuit and just put in 2 
> relays. I have everything working 95%.
>
> http://img846.imageshack.us/img846/5051/relaymirrorcircuit.png
>
> Now for my one small problem...
>
> Lets say I apply a steady 12V+ to the center circuit, now I activate 
> my left signal pulsing 12V+ on and off.
> You'll see my right LED flash slightly, then flash brighter until it's 
> flashing the same as my left signal.
>
> When the center circuit is dead both the left and right signals work 
> independently without issue.
>
> I THINK I just need to throw a diode on 87a on both relays right?
>
> [Non-text portions of this message have been removed]
>
> 



------------------------------------

Yahoo! Groups Links



[Non-text portions of this message have been removed]