AVR-Chat

Usually i program CKOPT only (check CKOPT, uncheck all 
others). I use ATmega8515. I made a mistake once using 
ponyprog. 1=programmed, 0=unprogrammed, right? 
Unfortunately in ponyprog there are no 1's or 0's. They 
use checkmarks. Checked=0, not_checked=1. Most of the 
times this confuses me. So, be careful when using them.

And dont fully believe what i say. Check the datasheets 
again, please. OK?

Regards,
Irfan.

On Mon, 19 Jul 2004 08:39:01 -0000
  "ereihani" <ereihani@yahoo.com> wrote:
> HI!
> (mega8535 or mega16 )
> I used  external clock  and read fuse bits all clear.(IN 
>PONY means 
> all ones)!!!(in contrast to data sheet).
> Then for crytal (7.3728MHZ)I did like this :
> 11110(ckel3...1=1,ckopt=1).
> but it didn't answer me at all(devic missing)!!!
> What should I do to use a crystal(7.3728MHZ).
> Please guide me!
> Thank you.
> 
> 
> 
> ------------------------ Yahoo! Groups Sponsor 
> 
> 
> Yahoo! Groups Links
> 
> 
> 
> 
> 

===========================================================================================
Netkuis Instan untuk wilayah Bandung (kode area 022) - SD,SMP,SMA berhadiah total puluhan juta rupiah... periode I dimulai 1 April 2004
===========================================================================================