AVR-Chat

Those are the 5 pins you need. On my cable I have the following
Grnd <- 18
MISO <- 10
MOSI <- 9
SCK  <- 8
RESET <- 7

And for the makefile paramters
MCU = atmega128
AVRDUDE_PROGRAMMER = bsd
AVRDUDE_PORT = lpt1 

AVRDUDE_WRITE_FLASH = -U flash:w:$(TARGET).hex
AVRDUDE_FLAGS = -p $(MCU) -P $(AVRDUDE_PORT) -c $(AVRDUDE_PROGRAMMER) 

Which is basically 
Avrdude -p atmega128 -P lpt1 -c bsd -U flash:w:$(TARGET).hex
Or just to test the connection you can use the -t

Avrdude -p atmega128 -P lpt1 -c bsd -t
then type help




-----Original Message-----
From: Jose [mailto:josecarlosfuentes@yahoo.com.ar] 
Sent: Friday, December 17, 2004 1:58 PM
To: AVR-Chat@yahoogroups.com
Subject: [AVR-Chat] Re: AVRdude - initialization failed




Since I am using a parallel programmer, and I already used it with 
AEC ISP software to program AT89S8252, I am sure it works fine (it 
just a cable that connects MISO, MOSI, SCK, RST and GND to the 
parallel port).
I checked continuity from the DB25 connector to the ATmega16 
programming pins, and everything is ok.  Also, I verified the power 
(5V).
I will check again the board circuit and the parallel port 
configuration.

Regards,
Jose

--- In AVR-Chat@yahoogroups.com, "Kenna" <wbounce@s...> wrote:
> I use it.  I do not have a 16 but a 128 so some thing may be
different. 
> First double check the continuity of your cable end to end for
each wire. My most recent problem with this error came from my 
ground wire coming loose because the board was in a different 
orientation
> 
> Second Check you battery power. With my 1st robot I would get this
error if the 7.2 V battery was low. It would drop under the voltage 
required for the voltage regulator on the board and so the board 
work get < 5V.
> 
> Third, after a long discussion someone set me straight on what
pins are used. for the 128 it is Port B pin 1 for SCK (clock) and 
Port E pin 0 for PDI (input) and Port E pin 1 for PDO (output)
> Check to see if you have anything external connected to these. And
Maybe also your reset pin since the programmer needs to pull reset 
to ground for 20ms.
> 
> Your mileage may vary.
> 
> 
> 
> ---------- Original Message ----------------------------------
> From: "Jose" <josecarlosfuentes@y...>
> Reply-To: AVR-Chat@yahoogroups.com
> Date: Fri, 17 Dec 2004 17:31:21 -0000
> 
> >
> >
> >Does anybody use AVRdude software?  I installed it and tried to
> >program an ATmega16 using a PPI programmer.  But AVRdude shows 
the 
> >following error message:
> >
> >  avrdude: AVR device not responding
> >  avrdude: initialization failed, rc=-1
> >           Double check connections and try again, or use -F to   
> >override
> >           this check.
> >
> >
> >I checked all the connections and they seems ok.  Since this is
my 
> >first AVR board I have no clue about the cause of this failure.
> >
> >Regards,
> >Jose
> >






 
Yahoo! Groups Links