AVR-Chat

I was going to go for the PCB shielding next. It does not have a ground
plane.
I used a 10k a pull up resistor on int0, I'll try 1k.
What is a "a snubber network on the contactor" ?

Thanx
JoeT

-----Original Message-----
From: Kathy Quinlan [mailto:kat-yahoo@kaqelectronics.dyndns.org]
Sent: Tuesday, February 10, 2004 2:10 AM
To: AVR-Chat@yahoogroups.com
Subject: RE: [AVR-Chat] Relay Control




> -----Original Message-----
> From: Joe [mailto:joet@attg.net]
> Sent: Tuesday, 10 February 2004 3:40 PM
> To: AVR-Chat@yahoogroups.com
> Subject: [AVR-Chat] Relay Control
>
>
> I am using a Atmega16 running at 7.37Mhz.
>
> I am also using a LCDPlus. I talk to it with the Rs232 Hardware UART.
> It has a ULN2803A with 8 relay Darlington Drivers. This also includes
> blocking diodes. I am using 5v Relays with contacts rated at 250v 10a.
>
> The setup uses a momentary button to interrupt on Int0. The relays
> energise Mains contactors 120v 1a and ring a bell 120v .6a.
> The system works fine with no load on the relay contacts.
>
> When I connect the contactor and bell I get false interrupts. I can
> software out the problem by disable/enable Int0 before and after the
> relay call. But I would like to fix it.
>
> What I have done:
> Use 1 supply for relays and 1 for the AVR.
> Adding a power line filter before the power supplies.
> I used a car battery and a dc to ac inverter to Isolate the unit from
> the contactor power.
>
> So far no real fix.
> Any Ideas??
>
> JoeT

Ground plane for the PCB, Shielded metal box for the PCB, a snubber
network on the contactor, a pull up resistor on int0 pin (1K).....

This is a common problem, with lots of answers, the above is just a
start.

Regards,

Kat.

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.580 / Virus Database: 367 - Release Date: 6/02/2004





Yahoo! Groups Links