AVR-Chat

Yes, but the part has that interface turned off by default from the factory, 
so you need the serial interface to turn it on before you can use it.

I'm sure they did this so that the reset pin is just a reset pin by default, 
but I think they could of done this smarter.. *Shrug* 

-Micah 

On Wednesday 28 December 2005 2:00 pm, John Samperi wrote:
>  At 04:59 PM 28/12/2005, you wrote
>
>  >The DebugWire interface is what I would like to use to program the chip
>  > in production, but to turn on that interface, apparently you need to set
>  > something using the serial interface.
>
>  Doesn't Debugwire use just the Reset pin? I haven't used it but
>  from what I understand you JUST need that pin which will need
>  to be setup for it (i.e. disable the Reset function)
>
>
>
>  Regards
>
>  John Samperi
>
>  ********************************************************
>  Ampertronics Pty. Ltd.
>  11 Brokenwood Place Baulkham Hills, NSW 2153 AUSTRALIA
>  Tel. (02) 9674-6495       Fax (02) 9674-8745
>  Email: john@ampertronics.com.au
>  Website  http://www.ampertronics.com.au
>  *Electronic Design * Custom Products * Contract Assembly
>  ********************************************************
>
>
>
>
> YAHOO! GROUPS LINKS
>
>
>  Visit your group "AVR-Chat" on the web.
>  
>  To unsubscribe from this group, send an email to:
>  AVR-Chat-unsubscribe@yahoogroups.com
>  
>  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.