AVR-Chat

Hallo All,
First of all I agree to use AVRStudio... it's free so why not! And 
than you indeed have to use PE0 and PE1! 
It's quite easy: in stead of PIN12(MOSI) you must connect MOSI to 
PIN2, and where PIN13(MISO), it must be PIN3.
So:
In stead of PIN12 --> PIN2,
            PIN13 --> PIN3.
Hope you've got enough info!! Good luck!!
Gerrit de Waard

-  


--- In AVR-Chat@yahoogroups.com, Ralph Hilton <ralph@r...> wrote:
>
> On Wed, 18 Jan 2006 18:27:29 -0800 (PST) you wrote:
> 
> >hi...
> >   got some problem regarding how to program Atmega128
> >  i using ponyprog2000, and use STK500 uploader, use 
MOSI,MISO,RESET,SCK...
> >  but can't upload.
> >  someone,tell me that i have to connect pin2(PE0) and pin3 (PE1) 
for programming....
> >  but i don't know how to do it....can anybody give some 
explaination??
> 
> There is a schematic for an ATmega128 dev. board on www.olimex.com 
that shows the
> connections.
> 
> >  for security fuse bit, i programmed for 
JTAGEN,BOOTSZ0,BOOTSZ1,SUT0....
> >  (since i'm using external 8MHz oscllator)....
> >  i suspect its got some problem with that, because there was no 
wave at Xtal..
> >  i have try to place with other oscillator, but still the same....
> >  is there anything wrong with my fuse setting? how to set so that 
it can work?
> >  thanks...
> >  really appreciate for your help ....
> 
> I would try using AVRstudio to program fuse bits. The options are 
detailed more clearly.
> I had a lot of problems with Ponyprog messing up fuse bits.
> --
> Ralph Hilton
> http://www.ralphhilton.org
> C-Meter: http://www.cmeter.org
> FZAOINT http://www.fzaoint.net
>