AVR-Chat

I do not have the ponyprog but sometime use a different programmer. I
had in the past corrupted the fuse bits. To get things working again I
had to connect another board to the xtal1 and 2 and generate a 1mhz
pulse on the other board long enough for me to reprogram the fuse bits
to the right clock setting

-----Original Message-----
From: AVR-Chat@yahoogroups.com [mailto:AVR-Chat@yahoogroups.com] On
Behalf Of Jeffrey Engel
Sent: Tuesday, March 14, 2006 10:05 PM
To: AVR-Chat@yahoogroups.com
Subject: Re: [AVR-Chat] Programming ATMega128


I had a simillar problem with PonyProg and an ATmega8.
 In my case, I had programmed the fuse bits the
opposite of what I thought I had.  Naturally, I blame
PonyProg for being non-intuitive and confusing me. . .
<grin>

Good Luck!

Jeff Engel
Arlington, TX  USA
--- filipesbp <filipesbp@sapo.pt> wrote:

> Hi,
> I use Ponyprog and the parallel programmer of the
> Ponyprog page,
> I've started to use the Atmega128 and i wanted to
> use a cystal 
> oscilator, so i've tried to program the fusebits, in
> ponyprog i've 
> make a reading of the fusebits, changed the CKOPT
> and the CKSEL, after 
> that i make a write.. 
> Now the problem, after that i've can not read or
> write the ATmega, 
> what it i do wrong? 
> I've tried t scope the pins and the MISO pin (PE1)
> is always at 1.


Happiness is - positive intake manifold pressure.

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 


 
Yahoo! Groups Links