AVR-Chat

Hi John,
   
  Thank you for the comment. I was using ATmega16 before and reseting the device is doing the otherway around.
   
  mago
   
  

John Samperi <samperi@ampertronics.com.au> wrote:
          At 12:43 PM 23/01/2007, you wrote:
>I am puzzled on AT89C2051...datasheet
>says that holding the reset high will reset the device... DOes this
>mean i have to pull down the reset pin?

Correct, this chip is not an AVR. Some micros do need the reset
to be high some to go low.

Regards

John Samperi

********************************************************
Ampertronics Pty. Ltd.
11 Brokenwood Place Baulkham Hills, NSW 2153 AUSTRALIA
Tel. (02) 9674-6495 Fax (02) 9674-8745
Email: john@ampertronics.com.au
Website http://www.ampertronics.com.au
*Electronic Design * Custom Products * Contract Assembly
********************************************************



         

  
---------------------------------
Looking for earth-friendly autos? 
 Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.  

[Non-text portions of this message have been removed]