AVR-Chat

At 09:41 PM 26/01/2007, you wrote:
>you can't program with DW and can't have both ISP and DW enabled at 
>the same time,
>so the program/debug cycle isn't exactly seamless.

True, but why would you want to both program and debug at the same time
on the same chip that has DW enabled? Set the fuses BEFORE you start a DW
session, then simply "Build and run" from then on. The new code will be
automatically download into the chip each time you have a successful build.

You don't even have to program the DW fuse as many people mistakenly do,
this will also be done automatically the first time you start a debugging
session. Once you finish debugging simply disable DW from within a DW
session and your chip is as good as new....well minus a few hundred write
lives :)


Regards

John Samperi

********************************************************
Ampertronics Pty. Ltd.
11 Brokenwood Place Baulkham Hills, NSW 2153 AUSTRALIA
Tel. (02) 9674-6495       Fax (02) 9674-8745
Email: john@ampertronics.com.au
Website  http://www.ampertronics.com.au
*Electronic Design * Custom Products * Contract Assembly
********************************************************