AVR-Chat

Thank you Steve,

Is the mating connector something special, or it could be made from IC 
sockets or headers?  Just because I don't know where I would get the mating 
connectors...

I'm not sure I understand the FW phrase:  what comes on the module, and what 
would I need to load separately, and I may only get if I buy the devkit?

I know I need the high power ones...

Thanks again,

Cat

----Original Message Follows----
From: "stevech11" <stevech@san.rr.com>
Reply-To: AVR-Chat@yahoogroups.com
To: AVR-Chat@yahoogroups.com
Subject: [AVR-Chat] Re: Zigbee modules etc, etc
Date: Fri, 09 Feb 2007 04:04:13 -0000

Re: Zigbee modules etc, etc

I have the Maxstream Dev kit and a lot of modules (and some from other
vendors too).

The Maxstream dev kit gives you motherboards for the modules and these
provide RS232 or USB plug and play. If you get the mating connector
for the modules, you don't really need the motherboard, unless you
wish the convenience.

The modules are downloaded with firmware to run in the 802.15.4 mode
WITHOUT ZigBee routing, or with the ZigBee firmware. Depends on what
you want to do.

The X-CTU config tool for a PC is likely a free dowload. It's essential.

The manual is needed - likely a free download.

Carefully look at your requirements before choosing between the $19
XBee 1mW radio and the $33 XBeePro 60mW module (prices I've seen at 1
each).  With a 2dBi gain antenna, some call the 60mW (Pout) 100mW
(radiated power includes antenna gain).





Yahoo! Groups Links



_________________________________________________________________
Don�t waste time standing in line�try shopping online. Visit Sympatico / MSN 
Shopping today! http://shopping.sympatico.msn.ca