AVR-Chat

AVR Development wrote:
> Okay, I soldered in the 40 pin socket and plugged an ATmega32 in it.  I did
> the firmware upgrade (communication between the PC and the AVR Dragon is
> just fine).  But when I go to start debugging and select the AVR Dragon and
> Target processor ATmega32 I get this error message:
> 
> "Failed to identify target.  Would you like to retry with external reset
> enabled?"

Did you install a 20x2 header connector to the board (which provides
the connections to the 40-pin socket)? Did you connect (with jumper
wires) the ISP or JTAG pins from the dragon to that 20x2 pin connector
so that the Dragon is connected with your 40-pin socket?

-- 
Kevin Rosenberg
kevin@hypershots.com