AVR-Chat

I wrote the previous as soon as I could, in case speed was of the essence... 
to save your board.
Then I gave it some thought, and... sure a diode is shorted, but I think it 
should still work.

Sorry about that :-)

Cat

----Original Message Follows----
From: "Cat" <catalin_cluj@hotmail.com>
Reply-To: AVR-Chat@yahoogroups.com
To: <AVR-Chat@yahoogroups.com>
Subject: Re: [AVR-Chat] clock speed
Date: Sat, 23 Jun 2007 22:24:12 -0600

I may be wrong, but DISCONNECT THAT IMMEDIATELY! USE A WALLWART!

Ground of PC should not go to the power connector of the STK500, because
there's a bridge rectifier there...
You might have blown it.

If I'm wrong, sorry about the panic :-)

Cat
----- Original Message -----
From: "Thomas Keller" <tjkeller1@alltel.net>
To: <AVR-Chat@yahoogroups.com>
Sent: Saturday, June 23, 2007 7:30 PM
Subject: [AVR-Chat] clock speed


 >
 > OK. I am  new to development kits/systems.  I have my STK-500 set up
 > with power (beibng stolen from a disk drive power connector in my PC)
 > and the serial connection.   When I try to program in the switches and
 > LED sample program, it fails, and the tip suggests checking clock
 > frequency setting.  WHERE am I supposed to check that, and where do I
 > set it?
 >
 > tom
 >
 >
 >
 >
 > Yahoo! Groups Links
 >
 >
 >
 >




Yahoo! Groups Links



_________________________________________________________________
Fight Allergies With Live Search 
http://search.live.com/results.aspx?q=Remedies+For+Spring+Allergies&mkt=en-ca&FORM=SERNEP