AVR-Chat

I use Altium Designer which has an automatic system for generating Atmel qtouch pads and wheels. You tell it the thickness of your overlay panel and the touch size required and it will make them for you. It is an expensive bit of software though.

-- 
Tim Mitchell
tim@sabretechnology.co.uk
t: 01482 800981 f: 01482 801078



[Non-text portions of this message have been removed]

I was going to mention the same as I also use Altium Designer but have not
yet tried out the QTouch stuff yet. I also have the Atmel QTouch Studio
installed and fancy making up a test board just to try it out.

 

Have you done any yourself Tim?

 

Would also be interested to hear from anyone else who has use the QTouch
Studio with any of the AVR devices that it supports?

 

Dave...

From: AVR-Chat@yahoogroups.com [mailto:AVR-Chat@yahoogroups.com] On Behalf
Of Tim Mitchell
Sent: 20 June 2012 15:53
To: AVR-Chat@yahoogroups.com
Subject: RE: [AVR-Chat] artwork for touch wheel

 

  

I use Altium Designer which has an automatic system for generating Atmel
qtouch pads and wheels. You tell it the thickness of your overlay panel and
the touch size required and it will make them for you. It is an expensive
bit of software though.

-- 
Tim Mitchell
tim@sabretechnology.co.uk <mailto:tim%40sabretechnology.co.uk> 
t: 01482 800981 f: 01482 801078





[Non-text portions of this message have been removed]