AVR-Chat

Greetings,

I'm presently working on a project using an ATMega32 with a MAX7128S 
Altera CPLD. Problem is...the Altera PLD's have their JTAG disabled, 
so I cannot program them (I got them as board pulls, used). I 
understand to re-enable this, the parts need to be cleared in a 
device programmer. Anyone know where I can find someone to do this? 
I have about 20 parts needing to be jtag re-enabled.

Thanks, 

A.D

--- In AVR-Chat@yahoogroups.com, Zack Widup <w9sz@p...> wrote:
> Is that part still being manufactured?  I'm not familiar with it.
> 
> Is it an SMD device?  I usually don't try to re-use those.  I've 
been 
> using EPM3064 devices (MAX3000 series) new They are relatively 
cheap.
> 
> Zack
> 
> On Mon, 1 Nov 2004, rastoboy wrote:
> 
> > 
> > Greetings,
> > 
> > I'm presently working on a project using an ATMega32 with a 
MAX7128S
> > Altera CPLD. Problem is...the Altera PLD's have their JTAG 
disabled,
> > so I cannot program them (I got them as board pulls, used). I
> > understand to re-enable this, the parts need to be cleared in a
> > device programmer. Anyone know where I can find someone to do 
this?
> > I have about 20 parts needing to be jtag re-enabled.
> > 
> > Thanks,
> > 
> > A.D
> >

Yea, as far as I know, it is still being manufactured. Its from the 
MAX7000 family. It is an 84 pin PLCC, appears to be pulled from a 
socket.

-A

Is that part still being manufactured?  I'm not familiar with it.

Is it an SMD device?  I usually don't try to re-use those.  I've been 
using EPM3064 devices (MAX3000 series) new They are relatively cheap.

Zack

On Mon, 1 Nov 2004, rastoboy wrote:

> 
> Greetings,
> 
> I'm presently working on a project using an ATMega32 with a MAX7128S
> Altera CPLD. Problem is...the Altera PLD's have their JTAG disabled,
> so I cannot program them (I got them as board pulls, used). I
> understand to re-enable this, the parts need to be cleared in a
> device programmer. Anyone know where I can find someone to do this?
> I have about 20 parts needing to be jtag re-enabled.
> 
> Thanks,
> 
> A.D
>