Digital BW, The Print

I have an Epson Stylus 1400 and cartridges from MIS.

I have to physically check the levels as the automatic part does not work.

I cannot get them to reset.

Possibly there is an issue with QTR which I use exclusively to print.

Mike J.

 

 

  _____  

From: DigitalBlackandWhiteThePrint@yahoogroups.com
[mailto:DigitalBlackandWhiteThePrint@yahoogroups.com] On Behalf Of Louis de
Stoutz
Sent: Saturday, March 05, 2011 6:45 AM
To: DigitalBlackandWhiteThePrint@yahoogroups.com
Subject: Re: [Digital BW] Re: New printer

 

  

Thanks everybody for your replies!
Is this normal behavior, not to indicate ink levels?
Is everybody else also checking ink levels "physically"?
Louis

On 05.03.2011 03:22, ddandan12 wrote:
>
> I did just this, loading MIS EB-6 cartridges straight from the boxes (both
the new r1400 printer box and the EB-6 cartridge set box). Everything went
fine and is still going fine 2 weeks later.
> The only issue I have is that I have never had a 'low ink' signal and the
software display of ink remaining is flawed. The indicators simply go down
and then flip back to full at their own volition, independent of the amount
of ink actually in the cartridge.
> I now check the cartridges by removing them every now and then, and refill
when low. After removing the cartridges to check level, I push the 'ink'
button again to relaod/reprime/whatever it likes to do. And I run a nozzle
checks after this.
> After a few days, you'll be able to tel when a print is missing an ink if
you lose track.
> I ran the alignment procedure once and it seemed to work ok.





[Non-text portions of this message have been removed]