Digital BW, The Print

I've been using the MIS-VM inks with a 1270 with moderate success. 
After reading Nigel Rheam's post on the Piezography message board, I 
tried something today. I went to the Epson web site and downloaded 
the 1280 driver. I installed this on my computer, and then printed 
with the 1280 curves, pretending that my 1270 was a 1280. 
Interestingly enough, results with the Roark 1280 mw curve and the 
Tyler CRV08 were better than with the 1270 curves. The stepwedges 
produced were more linear in both cases. 

Perhaps other users can verify this finding. If so, this might be the 
solution to using the 1270 with other MIS inksets as well.

Evan Wolarsky