Digital BW, The Print

Thanks for the tip Evan. Just curios, did you try any of those curves
through the 1270 driver too?

Todd

> I've been using the MIS-VM inks with a 1270 with moderate success.
> After reading Nigel Rheam's post on the Piezography message board, I
> tried something today. I went to the Epson web site and downloaded
> the 1280 driver. I installed this on my computer, and then printed
> with the 1280 curves, pretending that my 1270 was a 1280.
> Interestingly enough, results with the Roark 1280 mw curve and the
> Tyler CRV08 were better than with the 1270 curves. The stepwedges
> produced were more linear in both cases.
> 
> Perhaps other users can verify this finding. If so, this might be the
> solution to using the 1270 with other MIS inksets as well.
> 
> Evan Wolarsky