Digital BW, The Print

Moreno,

that looks like a good alternative to velcro. Thanks!

Jerry

Moreno Polloni wrote:
> 
> > What fasteners and where do you get them? Never heard of anything but
> > velcro, which isn't all that hot.
> 
> What I used was the "3MT Dual LockT Low Profile Reclosable Fasteners". These
> come in a few different shapes and sizes. Basically, it's a pliable plastic
> strip that has little mushroom-shaped projections. Both halves are
> identical, and snap together (which requires a bit of pressure). Once the
> two halves are joined, you can flex the CIS arm up and down several inches
> and the fastener holds firm. You could probably even lift the entire printer
> up a few inches before the two halves release. The 3M adhesive is very good.
> It stays in place, yet can be removed cleanly if need be.
> 
> I think Home Depot and a few other hardware stores may carry a similar
> product in small pre-pack squares.
> 
> You can see what the 3M stuff looks like at
> http://cms.3m.com/cms/GB/en/0-165/iRlreFV/view.jhtml
> 
> -mp
> 
> 
> Please visit the Group Homepage to check the Files, Bookmarks, Polls and other resources as they are often being updated. The page is at:
> 
> http://groups.yahoo.com/group/DigitalBlackandWhiteThePrint
> 
> Please follow these basic guidelines:
> - Include your full name with your message.
> - Include the address of your website, if you have one.
> - As threads develop, trim off excess portions of earlier messages to keep them short.
> - As the topic of a thread changes remember to change the subject header.
> - Good manners are required at all time. No personal attacks or "flames."
> - Complete your Yahoo profile.
> - Before posting a question, search the message archives and the various resources on the homepage.
> 
> 
> 
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/