Digital BW, The Print

As Roger said you are muxt be missing C compiler. One note to add 
which might be of some help later: you may also have to give the 
relative paths to these executive scripts. For me, this was the case 
at the next stage where i had to run ¨./sh install-quadtonerip¨ or 
¨sh ./install-quadtonerip¨ to have it run (i don´t remeber which 
one) while the instruction manual that comes with the software does 
not mention this possibility and without giving the relative path, i 
was getting the error ¨command not found¨. 
  Regards, Ramin 
 
--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Tom Husband" 
<thusband@s...> wrote: 
> Everything goes well until I get to "sh make-quadtonerip".  I 
press 
> enter and get some error messages.  I'm not sure where to look to 
fix 
> it.  The install instructions say it's usually due to a missing 
> cups-config but right at the start I did "locate cups-conf" and 
> /usr/bin/cups-config turned up on the list.  The error messages I 
get are: 
>  
> [root@localhost share]# cd QuadToneRIP2-beta/ 
> [root@localhost QuadToneRIP2-beta]# ls 
> CurveDesign          make-quadtonerip  QTR-LinuxNotes.pdf  
> SourceReadMe.rtf 
> CurveSrc             PPDs              quad.convs 
> Gimp-Print-Info.pdf  Profiles          RasterSrc 
> install-quadtonerip  qpr               ReadMe.html 
> [root@localhost QuadToneRIP2-beta]# sh make-quadtonerip 
> cc -g -O   -c -o qline.o qline.c 
> make: cc: Command not found 
> make: *** [qline.o] Error 127 
> cc -g -O -I. -DQUADPATH=\"`cups-config --datadir`\"   -c -o 
> quadraster.o quadras 
> ter.c 
> /bin/sh: line 1: cc: command not found 
> make: *** [quadraster.o] Error 127 
> [root@localhost QuadToneRIP2-beta]# 
>  
>  
> Any help sure would be appreciated.  I'm gettin' close. 
>  
> Thanks, 
>  
> Tom