Digital BW, The Print

Hello,

I have been lurking some time on this list, and now I have my outing :-)). I
have learned a lot by just reading your mails and comments, and I like this list
a lot, but now I have a question:

Recently I have seen several prints made by MIS inks, and immediately I ordered
VM Hex Inks and a CIS for my Epson Photo Ex. The customs has told me that it has
already arrived, and I am looking forward to install it. However, I was not
successful in finding any workflow and curves for the Photo Ex. Is there any
setting I could use, or should I try to get another Epson printer. 

Thanks a lot,

Ernst

Ernst
Nusterer

Ernst,
         I'm working on tweaking Paul Roark's Epson 1200 curves for the 
PhotoEX (Win2K). The curves seem to be very printer specific and need to be 
adjusted a bit for each printer and platform. So far I've gotten pretty 
close on the "neutral-cool" or "nc" curve. I'd be happy to share my results 
with you, or anyone else. My next project will be to tweak the 
"medium-warm" or "mw" curve. On my system this curve actually seems to 
print  nearly neutral (r=g=b). I've installed the CIS from MIS so let me 
know if you have any questions. My setup went pretty smoothly and did not 
need all of the cleaning and purging cycles that are suggested in the 
instructions. Good luck. Contact me off-list at deangelj@....

Jack DeAngelis


At 10:24 AM 11/28/2001 +0000, you wrote:

>Hello,
>
>I have been lurking some time on this list, and now I have my outing :-)). I
>have learned a lot by just reading your mails and comments, and I like 
>this list
>a lot, but now I have a question:
>
>Recently I have seen several prints made by MIS inks, and immediately I 
>ordered
>VM Hex Inks and a CIS for my Epson Photo Ex. The customs has told me that 
>it has