Doepfer

hello,
i had the same problem with a few of my a111's.
just plug a minijack cable into the hard sync input.
leave it there and then i think the problem will
dissapear. it is a problem with the hard sync input
minijack socket... you can permanently correct this
problem (so you don't have to leave plugged a cable to
the hardsync socket all the time...), i guess, with
the instructions that are present in the doepfer
website in the faq page. there is some touching of the
metal plates going on inside the minijack socket. i do
not exactly remember how i corrected this, but i think
that was the procedure described in the doepfer faq
page.
tell me if pluggin a cable into the hard sync input
corrected your problem first, though.
best regards,
Bakis.




--- Markus Grieß <markus.griess@gmx.net> wrote:

> Hi, I'm new to the group and have set my A100 to
> operation for the first time a few days ago. I have
> one question concerning the high end VCO A-111. When
> I modulate the PCV-Input with an LFO and turn the
> PCV knob clockwise, there is also a weak FM in all
> signal outputs, bad enough not to use PWM.
> 
> Is this a fault in my VCO, and is there any solution
> for it?
> 
> Best regards, Markus
> 
> [Non-text portions of this message have been
> removed]
> 
> 


Bakis Sirros - Parallel Worlds
[Doepfer_a100] group owner
http://www.parallel-worlds-music.com
http://www.myspace.com/parallelworldsmusic
http://www.shimarecords.co.uk
http://www.rubber.gr
Athens-Greece

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com