Doepfer

this is the exact thing i use the S&H and CV mixer combo for...i take a high (note) cv out of my midi> cv  box (a Roland MPU 101) and feed it into the &H, triger it once, and take the output in to the cv mixer...then i can combine any cv  combo into an osc   and use the S&H out   to sweep as far as i want ...i  was going to get the manual cv source (A176?), but after i figured it out i decided i didn't really need it....but imho everyone should own a dual S&H, it's very usefull...and a cv (linear) mixer...

(sorry, i'm horrible at remembering the Doepfer numbers, actually i wish people would write the mod names out so i don't have to look them up so much :) )


----- Original Message ----
From: Silas Johansen <sijodk@gmail.com>
To: Doepfer_a100@yahoogroups.com
Sent: Monday, June 18, 2007 11:42:01 AM
Subject: Re: [Doepfer_a100] Re: adding cv offset



Also, the tuning range of my VCOs is limited to a couple of half tone steps.
Detuning one by a larger amount requires the use of a constant CV source and
either a mixer or the CV2 input - this module, esp. with an unattenuated
input, would be a killer for "fat fifth" type sounds.

What I'm describing above is similar and in my opinion superior to the
dotcom q125.

/Silas

On 6/18/07, hardware@doepfer. de <hardware@doepfer. de> wrote:
>
> > ... but i'm surprised that there is no dedicated offset module -
> > something like 4HE with an input, output and a +/- knob that
> > could regulate a constant output when nothing is connected to the input.
>
> With a few exceptions (e.g. A-132) both an offset control and a control
> voltage input with attenuator are available for each voltage controlled
> parameter of a module. This is why normally separate offset generators and
> attenuators are not necessary in the A-100.
>
> If necessary (e.g. as an offset for the A-132) the manual CV source A-176
> could be used as an offset generator. This is why I don't see the
> necessity
> of a dedicated offset module. But I'm open for suggestions if I overlooked
> something.
>
> Best wishes
> Dieter Doepfer
>
> 
>

[Non-text portions of this message have been removed]




[Non-text portions of this message have been removed]