Doepfer

You probably speak about the but cruncher mode ?
It works in a linear way, i.e. the CV (generated by the manual control or
external CV) is proportional to the number of bits. The change in the
resulting sound becomes more dramatic for smaller values, i.e. the step from
8 bit to 7 bit is much less audible than from 4 to 3 bit or 3 to 2 bit. But
for other modes (e.g. the bit shifting/rotating) all steps have the same
amount of effect. After all it depends upon the selected mode and the
calculations for this mode how the CV affects the sound.

As Christian Assall is the man behind the A-189-1 firmware I ask you to
contact him directly for suggestions concerning software
changes/improvements (software@doepfer.de).

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto:Doepfer_a100@yahoogroups.com]Im Auftrag von Herman Pearl
> Gesendet: Samstag, 27. September 2008 19:36
> An: Doepfer_a100@yahoogroups.com
> Betreff: [Doepfer_a100] Re: Bitcrunch shootout?
>
>
> No other thoughts on the 189-1?
> Any special tricks or favorite uses?
> I haven't heard much about this module since i got mine.
> In messing around a bit more it feels like in terms of
> grit and grime, 0 being clean and 10 being dirty:
> The Malgorithm in regular mode goes from 0 to 12
> The 189-1 in most modes goes from 2 to 37. Does this make
> sense? My unit is a "black knob" trade show demo. Maybe the
> scaling is calibrated differently in the regular production
> units. Deiter, if you're reading this: is it possible that
> the unit I have goes from a relatively "clean" (as in full
> sample and bit rate) to "dirty" (low sample and bit rate)
> in a manner where most of the change is taking place sooner?
> I can't easily explain it any other way.
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>