Doepfer

Hi Paul 

> -The 110´s output is louder than the 111´s.
Thats why you think, the 110 sounds fatter. Turn down the level of the
110's signal (measuring with your scope) and compare then.


> - The front panel on the A-111 shows a SAW waveform ( the sawtooth starts at
> the top and goes down to the bottom then resets at the top),  but in reality
> the module generates a RAMP waveform ( ramp goes up to the peak, then resets
> at the bottom and "ramps" up.).  Why is that?
There is no difference between the "Ramp" or "Saw". A simple inverter
changes inbetween. Forget it.

> - When I plug my oscilloscope into the 111´s PULSE out, the offset seems
> wrong to me. It looks something like this (i hope you all can see that):
In general Doepfer modules have not DC-offsetted outputs. Instead the
inputs of the following modules have capacitors for offsetting from the
DC.


> Within ten to twelve seconds it "glides up" to a normal offset:
This is an effect of your scope.

Florian
-- 
Florian Anwander                  |ConSol*  HP-Support
Tel.   +49.89.45841-133           |Consulting&Solutions Software GmbH
Fax    +49.89.45841-139           |Franziskanerstr. 38, D-81669 München
email: florian.anwander@consol.de |http://www.consol.de