Doepfer

Make sure all the socketted ICs are firmly pushed in. Also make sure that all the jack sockets are making good contact with your patch leads. The two signal paths share parts of the three main ICs, so I'm thinking that if they work for one section, then why not for the other, so it might just be something simple...

Tim
__________________________________________________________
Tim Stinchcombe 

Cheltenham, Glos, UK
www.timstinchcombe.co.uk

--- In Doepfer_a100@yahoogroups.com, "goodnessgrows" <goodnessgrows@...> wrote:
>
> the lower section of my a-156 is just putting out a steady 1.76 volts. i have the jumper set so the upper section is affected by the switches on the lower section, but the lower section doesn't work with the jumper in either position. the upper section works. any suggestions? it was working a few days ago, i don't think i did anything wrong to it.  thanks very much.
>