Doepfer

Does the input of the A-119 accepts 48v ?
Thanks
Simon

--- In Doepfer_a100@yahoogroups.com, "Simon" <christensen.simon@...> wrote:
>
> Okay, thanks.
> I want to switch between at least ten different audio signals going into four different "effect-chains". 
> So lets say that the audio signal goes into the A-119, then into the A-182 and then sending four signals to two A-150. 
> Now it's possible to distribute the audio signal between the four chains.
> But this means that I need to control two CV inputs from a midi/CV interface for each audio signal and in the end, that's a lot!
> Here I was hoping that I could control all these CV inputs with two MT9 MIDI to Trigger/Gate converter from Analogue Solutions.
> 
> This solution means that I need to buy twenty A-150, seven or eight A-182, ten A-119 and then a mixer - like three A-138 for each chain - inserted before the four chains. 
> So twelve A-138!
> After the 4 chains I want the output send to A-134, but also to the other chains.
> This i controlled in Max/Msp, because the output of the A-134 goes into the laptop.
> 
> I have been thinking about this setup for a long time, but I still believe that there must be a more simple solution....
> 
> Simon
> 
> --- In Doepfer_a100@yahoogroups.com, <yahoo@> wrote:
> >
> > > Thanks for the fast reply.
> > > What about a trigger signal ?
> > > I will use the A-150 as a gate for audio signals and control
> > > which output should be enabled. It's important for me to control
> > > it from Max/Msp.
> > >
> > > Thanks.
> > > Simon
> > 
> > If you have an interface available that generates a gate signal (not a
> > trigger, that's only a short pulse) from Max/Msp it will work, i.e. you can
> > control the switching between two audio signals from Max/Msp.
> > 
> > Best wishes
> > Dieter Doepfer
> >
>