Doepfer

Hi Florian,

I think we will replace the top right socket (Start) by a momentary switch
and change the direction of socket below the socket to input (instead of
output). The function of the remaining output sockets could follow the
results of an upcoming poll. There are also 3 internal jumpers. One is
already reserved for the output voltage levels (+5V/+12V). The remaining two
jumpers could be used e.g. to define the clock divider of one or two sockets
(e.g. 8/16). But the problem is that the front panel printing will not
change with the jumper setting :-) So the best conception would be to find a
solution that satisfies most users.

These functions are essential to control some A-100 modules (e.g. A-155 or
A-154)

* Start
* Stop
* Reset
* Clock (32 or 16 or 8 or ...)

These two outputs are required for applications with Roland DIN Sync
(potentially with a special cable 2x3.5 -> DIN):

* Start/Stop (or reverse),
* Clock 96, required for applications with Roland DIN Sync

And it's a good idea to have the "1" signal:

* Measure start (1)


Then 2 sockets are left for clock outputs, e.g. 32/16 or 16/8. Another
version would be only one clock output and a three-position switch for
32/16/8. But then only one clock output is available. If other clocks are
required the A-160 or A-161 may be used.

Best wishes
Dieter



> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto:Doepfer_a100@yahoogroups.com]Im Auftrag von Florian Anwander
> Gesendet: Freitag, 23. November 2012 17:14
> An: Doepfer_a100@yahoogroups.com
> Betreff: Re: [Doepfer_a100] Latest info from Dieter about new /
> forthcoming A100 modules!
>
>
> Hi Dieter
>
> Am 23.11.2012 16:48, schrieb yahoo@doepfer.de:
> > I'm not sure how important it is to have a large
> > button like the Mungo unit.
> Does size matter? ;-)
>
> But a push button plus an input socket would be cool. The question is
> then: where to find space for both? Me personally I do not need the 8th
> output. 32th and 16th and 1 is ok for me. But this should be a discussed
> by the community.
>
> Florian