Doepfer

Hi Bret,
The jacks Doepfer use are made by Cliff, and are available from a 
number of sources in the UK:

Maplin, order code CX94C, 49p (inc VAT)
www.maplin.co.uk

Rapid Electronics, order code 20-0140, 30p + VAT
www.rapidelectroncs.co.uk

Somewhat annoyingly the pins are 0.4 inches apart one way, and 0.15 
apart the other: if you're drilling your own holes no problem, but 
for 0.1" pitch strip board you'll have to bend two of the pins (I 
twist the 'back' pair by 90 degrees, then you can angle them to fit 
in the hole 0.2" from the front pair).

Hope that helps!

Tim

> Well, I know I've asked this question before, but I never got a 
response.  No worries, I know I'm a little off topic.
> 
> I'm building a module for my Doefper A-100.  Does anyone know which 
jacks (manufacturer/part number) are used by Doepfer, Analog 
Solutions, or Analog Systems?   Are there any other jacks that could 
do the job?  I'd like to solder the jacks directly onto the PCB board 
like they do.  The jacks should be threaded like Doepfer's too.  
> 
> Thanks!
> - Bret