Doepfer

Florian thanks again for the help, as far as I can see there’s no pre-post “point” where the leak might occur. Each signal goes straight to its target and nowhere else. Audio 1 multed signal and A-138s mixer outs have separated channels (1 mono, 1 stereo) on the outboard mixer, so I had muted the stereo channel and assured that no pre-sends were active on that channel: the A-138s channel 1 signal (DPO) was audible through the mono channel dedicated to the multed signal (softpop) which had to be recorded.

> Il giorno 12 giu 2018, alle ore 15:13, Florian Anwander fanwander@mnet-online.de [Doepfer_a100] <Doepfer_a100@yahoogroups.com> ha scritto:
> 
> Hello Diego
> 
> Am 12.06.2018 um 15:01 schrieb Diego Ragnini diegora@free.fr [Doepfer_a100]:
> >
> >
> > “Mixer” is not a module, is an outboard mixer, a Soundcraft GB2R 12-2 
> > where all audio signals are routed to.
> > It’s from its monitor outs (headphones) that I detected the leak.
> > It makes no sense to me.
> Where from do you know that the leak is not in the external mixer?
> 
> The same is valid  for the input signals Audio1 and Audio2. They might 
> might leak into each other before the rack
> 
> The only proof that there is a leaking caused by the A.138 or the WMD 
> would be to remove all external connections and then feed an internal 
> signal into the WMD and listen to the unused A-138. After that the other 
> way around: feed an internal signal into the Mixer and listen to the 
> (unused) WMD.
> 
> Everything else will be related to external gear or to the 
> interconnection with the external gear.
> 
> Florian
>