Doepfer

Hi all,

Florian is correct about needing high quality components for a switching panel.

This might be of interest though! It was designed for use with Larry's MOTM VCO's but will work with any make.

http://www.wiseguysynth.com/larry/diy.htm

I'm tempted myself.

Regards

David



                                                                                                                        
                    Florian Anwander                                                                                    
                    <Florian.Anwander@       To:      Doepfer_a100@yahoogroups.com                                      
                    consol.de>               cc:                                                                        
                    Sent by:                  Subject:     Re: [Doepfer_a100] Variable level waveform output on VCO     
                    Florian.Anwander@c        Header:      Internal Use Only                                            
                    onsol.de                                                                                            
                                                                                                                        
                                                                                                                        
                    18/01/2002 08:51                                                                                    
                    Please respond to                                                                                   
                    Doepfer_a100                                                                                        
                                                                                                                        
                                                                                                                        



Hi Roel

> thought, this is always the same, always fixed. Wouldn't I gain a lot more
> possibilities if the frequency of the waveform could be influenced on the
> output.
You think of a VCA that lowers/rises the Waveform level in proportion to
the note that is played? All you need is a VCA that is controlled by the
keyboard voltage.

> And another idea. A switch between octave and semitones on it as well!
> Moog had this on 921a Oscillator driver.
This is more elaborate and costly you might think, since you need high
precisision components. We talked in synth-diy maillist about this some
time ago.

Florian
--
Florian Anwander                  |ConSol*  HP-Support
Tel.   +49.89.45841-133           |Consulting&Solutions Software GmbH
Fax    +49.89.45841-139           |Franziskanerstr. 38, D-81669 München
email: florian.anwander@consol.de |http://www.consol.de

To unsubscribe from this group, send an email to:
doepfer_a100-unsubscribe@yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.





------------------------------------------------------------- ---
        Visit our Internet site at http://www.reuters.com

Any views expressed in this message are those of  the  individual
sender,  except  where  the sender specifically states them to be
the views of Reuters Ltd.