Doepfer

Hello,

I'm new to the list and Doepfer in general, so I apologize if my 
follow questions are really obvious. 

I've been piecing together a Doepfer setup over the last few months. 
All the modules are going into an A-100G3 frame. A couple of days ago 
I got a second VCO (a-110) and read that the A-100 bus can be set to 
do Internal CV and Gate - to send both VCOs the same CV/Gate signals. 
I do not have a full manual, but I downloaded the A100 "intro" pdf 
from the Doepfer web page and it talks about "altering an internal 
jumper" to set this up. I found the J1 and J2 jumpers between the 7th 
and 8th bus board connectors. With the jumpers connected the internal 
cv/gate did not seem to work. I pulled them out and still no internal 
cv/gate. So my basic question is where do the jumpers get connected 
to make internal cv/gate work?  Nothing on the bus board is 
labeled "INT.CV" as it appears in the pdf. Also, do I need to do any 
specific patching between VCO1 and 2 for this to work? Finally, I'm 
using a Kenton Prosolo to control the modular – should the Kenton 
work ok for what I'm trying to do? 

Thanks so much