Doepfer

--- Dieter Doepfer <hardware@doepfer.de> wrote:
> From: "Dieter Doepfer" <hardware@doepfer.de>
> To: "Bakis Sirros" <synth_freak_2000@yahoo.com>
> Subject: AW: [Doepfer_a100] vco octave switches
> Date: Thu, 1 Jul 2004 13:25:33 +0200
> 
> > -----Urspr�ngliche Nachricht-----
> > Von: Bakis Sirros
> [mailto:synth_freak_2000@yahoo.com]
> > Gesendet: Mittwoch, 30. Juni 2004 14:28
> > An: Doepfer_a100@yahoogroups.com
> > Betreff: Re: [Doepfer_a100] vco octave switches
> >
> >
> > hello all,
> > i agree with florian.i would prefer a vco with
> octave
> > switches(as the a110,a111)AND a pot for wide range
> > continuous tuning(like the vcs3 or the system100
> > vco's).would that be possible though?
> > bakis
> 
> It is no problem to change the sensitivity of any
> control or CV input of an
> A-100 module. Maybe we could add a corresponding
> hint to our (still hidden)
> A-100 DIY page. It simply depends upon the value of
> a resistor. The CV mixer
> on the DIY page (chapter 3. circuit examples) shows
> the principle. The
> values of the resistors R1...R4 define the
> sensitivity of the corresponding
> control resp. CV input. Almost each A-100 module
> (e.g. VCO, VCF, VCA) has
> this type of circuit available to add up all
> controls and CV inputs. For the
> A-111 e.g. these controls/resp. CV's are added up to
> create the final pitch:
> octave switch, tune, fine tune, CV1 and CV2 (with
> attenuator). For the A-110
> it is the same but only one tune control.
> It would even be possible to add a switch so that
> two or more different
> sensitivities are selectable.
> 
> Best wishes
> Dieter Doepfer
> 
> b.t.w. the address for the hidden link is:
> www.doepfer.de/diy/a100_diy.htm
> 
> 


=====
Bakis Siros
Parallel Worlds / Polariton
Athens-Greece
[Doepfer_a100] group owner
http://www.shimarecords.co.uk
http://www.ward12.com


	
		
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!
http://promotions.yahoo.com/new_mail