Doepfer

--- Dieter Doepfer <hardware@doepfer.de> wrote:

> From: "Dieter Doepfer" <hardware@doepfer.de>
> To: "Bakis Sirros" <synth_freak_2000@yahoo.com>
> Subject: AW: [Doepfer_a100] A190 issues..
> Date: Thu, 11 Nov 2004 17:39:54 +0100
> 
> > It's connected to the bus, so I can see the gate
> bus LED's lit when
> > there is midi data received, I have also tried
> patching it to any of my
> > A110 VCO's, still no use. It's odd, i know that
> the IC is working,
> > which would be the suspect thing if it were blown,
> as the gate outs are
> > okay.. so?? any ideas??
> 
> Explanation #1: There are 2 modules that "write" to
> the CV line of the bus.
> So far this could be the A-185 only (or two A-190).
> If you have an A-185 on
> the same bus the bus connections of the A-190 have
> to be interrupted as
> mentioned on page 4 in the A-185 manual.
> 
> Explanation #2: The A-190 is defective or completely
> misadjusted. Try to
> measure the CV at the CV socket at the front panel.
> If there is no CV coming
> out reset the A-190 as described in the A-190
> manual. After that the CV
> scale and offset of the A-190 have to be re-adjusted
> (i.e. VCOs controlled
> by the A-190 will probably be detuned especially
> because of the unadjusted
> 1V/octave scale).
> 
> Good luck
> Dieter Doepfer
> 
> 


=====
Bakis Siros
Parallel Worlds / Polariton
Athens-Greece
[Doepfer_a100] group owner
http://www.shimarecords.co.uk
http://www.ward12.com


		
__________________________________ 
Do you Yahoo!? 
Check out the new Yahoo! Front Page. 
www.yahoo.com