Doepfer

Thanks Florian for the links, that's basically what I had in mind.
 
It would be nice if it could work with both audio and CV and maybe with
centred pots with positive and negative swing.
 
I find many occasions when I want to send a signal to multiple
destinations but with the desire to attenuate on or two of the signals.
 
Looks like a project for the new year.
 
The matrix mixer would be great as I could then use it for combining
various CV's to make more versatile modulation sources.
 
Thanks again
 
David
 
David Salter
Senior Project Manager
Reuters Ltd
Tel       +44 20 7542 2402
Mob     +44 7990562402
email    david.salter@reuters.com
RM       david.salter.reuters@reuters.net
 
 

________________________________

From: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
On Behalf Of Florian Anwander
Sent: 13 December 2005 16:39
To: Doepfer_a100@yahoogroups.com
Subject: Re: [Doepfer_a100] A bit of help needed


Hi David

> At it's simplest it's 1 input feeding 4 outputs with level controls.
> Anyone have a simple schematic or suggestions?

Basically you are looking for something like a simple mixerchannel with 
4 aux sends. Right?

Do you want it for audio or for CV? Should it have the possibility of 
send inverted or not?


In principle you do not need anything else than a frontplate, four 
47k-pots (log for audio/lin for CV) plus knobs four 100k-resistors and 
five sockets.
Connect the input socket to the "upper end" solder pin of all pots.
Connect the "lower end" solder pin of all pots with ground.
Connect the center pin of each pot via a 100k-resistor to one output
socket.

So far so easy.

The trouble starts, when you want to mix several of such distributed 
signals in one source (like the Aux-Send-Master in a audiomixer). This 
requires a buffer amp. To avoid this you have to add a buffer-amp to the

each output.
Example: http://www.doepfer.de/DIY/amp_noninv.gif

Check out http://www.doepfer.de/DIY/a100_diy.htm and look for the matrix

mixer. Your distribution-module like a matrix mixer, but there is only 
one row of the input section as seen in the 
http://www.doepfer.de/DIY/matrix_mixer.gif



________________________________

YAHOO! GROUPS LINKS 


	
*	 Visit your group "Doepfer_a100
<http://groups.yahoo.com/group/Doepfer_a100> " on the web.
	  
*	 To unsubscribe from this group, send an email to:
	 Doepfer_a100-unsubscribe@yahoogroups.com
<mailto:Doepfer_a100-unsubscribe@yahoogroups.com?subject=Unsubscribe> 
	  
*	 Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service <http://docs.yahoo.com/info/terms/> . 


________________________________




To find out more about Reuters visit www.about.reuters.com

Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Reuters Ltd.



[Non-text portions of this message have been removed]