Doepfer

Hi A1k,

That little cable doesn't come as 'standard' with a G6, as far as I 
know: EMIS sell it as a 'bus link' cable for a few pounds. It's 
purpose is to link the 'gate' and 'CV' buses between the upper and 
lower busboards, so that if you have your A-190 plugged in either to 
the top or bottom row, other modules, wherever they are (either top 
or bottom), can 'see' these two signals. The link can either be 
between the 'gate' and 'CV' jumpers between the two boards (the 
jumpers are in the middle), or (as the EMIS cable does) it just plugs 
into a spare power connector top and bottom. (It is quite easy to 
make one up too.)

Tim

--- In Doepfer_a100@yahoogroups.com, "analog1k" <analog1k@...> wrote:
>
> I recieved another 6U case filled with modules today, however
> i am experiencing problems already with this new unit, I
> have noticed that on my existing 6U rack there is a 4-strip
> ribbon cable connecting the upper and lower bus-boards together
> what is this for ?
> 
> On my new 6U system, that 4-strip ribbon connection cable is
> missing, as some of the modules have failed to work not even
> any of the LED's light up? especially the PLL module.
> 
> Other problems are when i use my midi-analogue sequencer (a P3)
> connected to the A-190 MCV interface, all i get is a constant
> gate tone in the key C, although the sequencer is playing a
> 8-note sequence line, the doepfer responds by just playing one
> single note instead of 8 different ones, as I said there a cable
> missing between the lower and upper bus-boards.
> 
> I tested the A-190 in my other doepfer unit and it works fine,
> so that is not the problem ?
> 
> Should i contact EMISmusic (UK) and ask them to send me that
> 4-strip bus-board connector cable? 
> 
> Any info much appreciated
> 
> 
> Regards
> A1k
>