Doepfer

--- In Doepfer_a100@yahoogroups.com, "Dieter Doepfer" <hardware@...> 
wrote:
>
> A1k,
> 
> the 4-strip ribbon cable is not an accessory that we offer. Maybe 
the former
> customer has added this cable (or it is offered by the Doepfer
> representative in your country).
> 
> Yes! thanks Dieter, EMIS is the representative in the UK, I will
> be contacting them tomorrow and buying a bus-link connector.
>
>
> The only accessory that is a bit similar is the "A-100BC CV/Gate bus
> connection cable". But this only a 2 pin cable with a jumper 
soldered to
> each side of both cables. The cable (or even one wire only) can be 
used to
> connect the CV and/or Gate lines of 2 bus boards. E.g. if the A-190 
is
> located in the lower row and you have one or two VCOs in the upper 
row the
> CV line of the lower bus board can be connected to the CV line of 
the upper
> bus boards by means of this cable. For this the CV and Gate pin 
headers on
> the bus boards are used.
>
> This is the cable I need to get, it's only £2.00 to buy  :)
>
> 
> Details on page 9 and 10  of the A-100 user's manual (pin 
headers/jumpers
> J1,J2).
> 
> Pay attention that only one module is allowed to put CV and Gate to 
the bus
> (e.g. A-190 or A-185, not both). Otherwise a short circuit of two 
CV or Gate
> outputs is the result. Details in the user manuals of A-185 and A-
190.
>
> I only have two A-190's, one is in each seperate G6 case and are
> both independant from each other
>
> Gruss,
> A1k
>
> 
> Best wishes
> Dieter Doepfer