Elektor Formant Modular

Hi Mark
It's hard to tell what went wrong. The schematic diagram is quite simple, even with a simple multimeter you might check the action at different points. Did you connect the ground of the panel and connectors?

gerards regards


>Hi Formant guys,
>
>I had a working LFO module in an old formant Ive been restoring, I
>made a new panel, basically... it WAS working fine.
>
>I needed it to be in my Blacet rack so, cos they are both +15 -15
>machines, I wired on a blacet connector and plugged it into the
>Blacet psw.. all 3 LED's flashed as they are supposed to so I
>assumed it was all AOK... racked it up... but now when I try it, I
>dont seem to be getting any waveform out of the sockets, even when I
>patch it to a formant VCO.
>
>Why could this be?? is there something different between the Formant
>psu and the Blacet PSU???... that would make the LED's work but the
>module.. not...??
>
>I want to use it to sweep some Blacet CV'c, but can at a pinch
>cpnnect it to the formant PSU again, just that it will be in a rack
>that I DONT gig... as opposed to the one that I do...
>
>
>Help??
>
>mark
>
>
>
>
>
>
> 
>Yahoo! Groups Links
>
>
>


-- 
______________________ _
Gerard Bik grafische vormgeving
Van Aerssenstraat 263
2582 JM  Den Haag
070 3554081