-----Ursprüngliche Nachricht-----
Von: Ensoniq-VFX-SD@yahoogroups.com [mailto:Ensoniq-VFX-SD@yahoogroups.com] Im Auftrag von Johan Halmen
Gesendet: Samstag, 27. Oktober 2007 15:05
An: Ensoniq-VFX-SD@yahoogroups.com
Betreff: Re: [Ensoniq-VFX-SD] SD-1 Finally Concked OutOn Fri, 14 Sep 2007 23:23:59 -0000, Scott wrote
> My SD-1 has worked flawlessly since 1991 and toady it won't start.
> Power on and the drive chirps twice and that's it. If I hit enough
> buttons I can get "8"s on the screen. So, the question --- would a
> dead battery alone cause this or is this a sympton of something bigger?
That's exactly what my SD did last summer. I tried it again today, but no activity. Please tell if you got it
running. I think I had this problem 10 years ago and took it to service. I think they replaced the battery.
Maybe they also gave it an over all service (the spade lugs mentioned here etc). But I don't think I can
find any service in Finland anymore. I'm going to do that myself. Replacing the battery shouldn't be that
hard. Anyone done that? One must obviously solder it from same side that the pins go through the
board.
--
Johan Halmén
Message
AW: [Ensoniq-VFX-SD] SD-1 Finally Concked Out
2007-10-27 by Hans Artmann
There
are lots of answers to this in the archive. Although there are also lots of
instructions in the file section of the group for replacing the battery i guess
this is not your problem. The SD would say BATTERY LOW
first.
Look
for the fuses instead. They are placed in the power supply unit left hand when
you open the cover (and there's a main fuse at the back which I've never seen
blown).
Hans
;