Patches and discussion for Ensoniq VFX family

Greetings list, long time since my last post, but now I come for your expert help.
My SD-1 display, after about 10 minutes of working time, goes out. I can't read anything on it, but if I press it in some points, it will show up again but goes out in a matter of seconds. 
Does anyone know if this can be fixed? 
TIA for any advice,
 
Sandro Santos

		
---------------------------------
Do you Yahoo!?
 Yahoo! Small Business - Try our new resources site!

simply pop the hood and see if the wire connector going from the main 
board to the display is loose.
 Rich




--- In Ensoniq-VFX-SD@yahoogroups.com, adolfo dias <c0v3n4n7@y...> 
wrote:
> Greetings list, long time since my last post, but now I come for 
your expert help.
> My SD-1 display, after about 10 minutes of working time, goes out. 
I can't read anything on it, but if I press it in some points, it 
will show up again but goes out in a matter of seconds. 

> Does anyone know if this can be fixed? 
> TIA for any advice,
>  
> Sandro Santos
> 
> 		
> ---------------------------------
> Do you Yahoo!?
>  Yahoo! Small Business - Try our new resources site!

Hi there, thank you for your reply.
Is there any service guide or hints about opening it?
I really don't make any mistake. When you say hood you
mean the plastic display protector of the whole
keyboard? 
Sorry if this question is dumb, but I really don't
want to make any bad move on it.

TIA,

--- Richard <mishon66@...> wrote:
> 
> simply pop the hood and see if the wire connector
> going from the main 
> board to the display is loose.
>  Rich



		
__________________________________ 
Do you Yahoo!? 
Yahoo! Small Business - Try our new resources site!
http://smallbusiness.yahoo.com/resources/

Ya it's simple just take out the four set screws on the top panel, there are two on each end of the panel. Once the screws are removed simply lift the panel up, it is hinged to the back so it opens like a door. You will clearly see the connector going to the display.
 Richard at Route 66

-----Original Message-----
From: adolfo dias <c0v3n4n7@...>
To: Ensoniq-VFX-SD@yahoogroups.com
Sent: Tue, 12 Apr 2005 15:48:35 -0700 (PDT)
Subject: Re: [Ensoniq-VFX-SD] Re: Help with display



Hi there, thank you for your reply.
Is there any service guide or hints about opening it?
I really don't make any mistake. When you say hood you
mean the plastic display protector of the whole
keyboard? 
Sorry if this question is dumb, but I really don't
want to make any bad move on it.

TIA,

--- Richard <mishon66@...> wrote:
> 
> simply pop the hood and see if the wire connector
> going from the main 
> board to the display is loose.
>  Rich



        
__________________________________ 
Do you Yahoo!? 
Yahoo! Small Business - Try our new resources site!
http://smallbusiness.yahoo.com/resources/



 
Yahoo! Groups Links