Homebrew PCBs

bill afanaseff wrote:

>sorry i wasnt clear at all, i meant where you had your boards made :)
>
>
>  
>
  No problem, figured it might be just the quoting..

http://www.modellights.com/images/temp/pcb1.jpg
http://www.modellights.com/images/temp/pcb2.jpg
http://www.modellights.com/images/temp/pcb3.jpg

  A few pics to see what the $90 can get.  2.6" square, so 32 makes for 
~216 sq inches total, a bit more than the 200 from the ad, of course 
can't count on the extras..  Pic 3 shows one small error, the center 
trace comes out at 90, should have come out at 45.  Not a problem, but 
unnecessarily close to the hole beside..  Slight misalignment in the 
hole rows on the right in that pic is intentional, to move off a bit for 
clearance.  Been dealing with a water leak, so haven't even built one up 
yet, but it's a shrink of a known good larger version, so should be no 
real problems.  Could have made some clearances a little larger, but not 
much else, and had several 'last 2 days' additions, so not too bad.  
Making notes for the next round of boards..

  Tight two layer, would've been a royal pita to try to make 32 of these 
by TT or similar at once.  May get two boards next order, doubling up on 
the shipping would make it an even better bargain.

Alan