Homebrew PCBs

you need better heat thransfer equipment.


  ----- Original Message ----- 
  From: Kim Currier 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Saturday, January 21, 2006 10:15 PM
  Subject: Re: [Homebrew_PCBs] Re: PRess-n-peel blue


  Hi everyone. I purchased some press and peel Blue, and tried the first
  board. I was not real pleased, but I am SURE it isn't the products fault. I
  used the iron on the TOP of the mask plastic. I noticed that the center of
  the board was not very good, but the outside edges were distinct, and sharp.
  I was applying pressure on the board with the iron, and used a sheet of
  paper on the top so that it would move freely.

  I was wondering, should i pre-heat the board BEFORE I apply the
  press-n-peel? Should I heat the board while I have it on TOP of the pores
  and peel, or should I not press as hard as I did to make a good pattern turn
  out on the board?

  Thanks in advance!!

  Kim



  Be sure to visit the group home and check for new Links, Files, and Photos:
  http://groups.yahoo.com/group/Homebrew_PCBs

  If Files or Photos are running short of space, post them here:
  http://groups.yahoo.com/group/Homebrew_PCBs_Archives/ 



  SPONSORED LINKS Electrical engineering degree online  Electrical engineering degree  Printed circuit board  
        Electrical engineering  Electrical engineering course  Electrical engineering graduate school  


------------------------------------------------------------------------------
  YAHOO! GROUPS LINKS 

    a..  Visit your group "Homebrew_PCBs" on the web.
      
    b..  To unsubscribe from this group, send an email to:
     Homebrew_PCBs-unsubscribe@yahoogroups.com
      
    c..  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


------------------------------------------------------------------------------



[Non-text portions of this message have been removed]